rate of loading

The non-monotonic compression factors such as compression coefficient ratio a_e/ a_v, load ratio q_l/ q_u, rate of loading and that of unloading, all have significant influence on the consolidation behavior.

压缩系数比a e/a v、荷载比q l/q u、加载和卸载速率等非单调压缩因素对地基的固结性状均有明显影响。

Which can quantitatively reflect the effects of cyclic loading conditions, material properties and corrosion environment on the initiation life and propagating rate of the cracks.

这些表达式能定量反映循环加载条件、材料性能及腐蚀介质对裂纹起始寿命和裂纹扩展速率的影响。

The sensitivities of temperature and loading rate of the material are low.

该材料对温度和加载速率的敏感性较小。

Adopting the ability of loading adaptation rate and traffic capacity adaptation rate, the ability of drain off flood water adaptation rate and the ability of loading coincidence rate engage in calculation to synthesize to assess.

一般多采用承载能力适应率、通行能力适应率、洪水宣泄能力适应率以及承载能力符合率进行计算来综合评定。

From the experimental data, it shows that the mechanical behavior of the concrete exhibits anisotropy and is obviously different from that of the quasi-static loading under high rate of loading condition.

混凝土的实验数据表明其力学性质表现出很强的各向异性，并且在高加载速率的情况下，混凝土的性质和准静态时明显不同。

A series of k_0 consolidation tests under constant rate of loading were carried out on the loess ( Q_3), which comes from Longxi area in Gansu province.

采用恒荷重速率试验法，对甘肃陇西Q3原状黄土进行了k0固结试验。

Adjustment of variation rate of BOD loading and raising of DO content in mixed liquor can effectively control the sludge bulking.

通过调整BOD负荷变化速率、提高混合液中的溶解氧含量，可使污泥膨胀得到有效控制。

The strength of the concrete material is related to the rate of loading and the strain rate.

混凝土材料的强度与加载速度、应变速率有关；

The rate of loading should be 300 metric tons per workable hatch.

每个可使用的舱口的装货率应为300公吨.

One of the important parameters that have to be determined in pneumatic transport processes is the mass flow rate of particles or the loading ratio.

气力输送中必须确定的一个重要参数为固体颗粒质量流量或浓度。

Paper and board-determination of tensile strength properties-part 1: constant rate of loading method

纸和纸板-抗张性测定-第1部分：恒定加载法

Pass to carry on a series of uniaxial and unconfined compression test towards Huma river ice, it can be researched that the influence of temperature and rate of loading to compressive strength, strain-stress, elastic modulus.

通过一系列单轴无侧限抗压强度试验，对温度及加载速率对河冰抗压强度、应力&应变关系、弹性模量的影响进行了研究。

Prediction application of Haicheng m_s7.3 earthquake in MID-SHORT TERM using parameters ( y) of response rate of loading and unloading besed on active tectonic block boundary zones

基于活动地块边界带的加卸载响应比参数对海城地震中短期预测的应用

Probe into Flow Rate of Unloading and Loading Oil at Petrol Wharf

码头收发油流速问题探讨

The study shows that besides boundary conditions, the factors influencing the nonlinear consolidation behavior of soils are the compression index cc, the permeability index ck, the level and the rate of loading, and the thickness of soil, etc.

研究表明，除边界条件外，影响软土地基一维非线性固结性状的主要因素是压缩指数c c、渗透指数c k、荷载大小与加荷速率、土层厚度等。

The relation of strength under unloading and loading conditions is studied with respect to the rate of loading.

从加载速率角度研究了加荷和卸荷条件下所得强度的关系。

The average values of indentation creep rate sensitivities are independent of loading conditions, but are close related to the microstructure of the materials.

室温m的平均值与加载条件无关，而由材料的微观结构决定。

The influences on failure probability by resistance degradation function, average occurrence rate of loading and service time are analyzed qualitatively.

定性分析抗力衰减函数、荷载平均发生率和结构服役时间对失效概率的影响。

At high strain rate of loading, the damage mechanism of the high volume fraction particle reinforced SiCp/ Al composite associated with the fracture of the particles and the deformation localization of the matrix.

在高应变率压缩载荷下，无压浸渗高体积分数siCp/AI复合材料在增强相颗粒破裂的同时会出现局部化变形，材料的损伤行为与复合材料中的增强相颗粒尺寸密切相关。

Effects of temperature and loading rate on the flexural-tensile strength, strain and stiffness modulus of ATB-25 asphalt mixture were discussed using three-point bending test.

通过沥青稳定碎石基层ATB-25沥青混合料的三点弯曲试验，研究了温度及加载速率对弯拉强度、弯拉应变及弯曲劲度模量的影响规律。

A calculation and an analysis of the production rate of the loading and drawing of rocks in shafts

竖井装岩提升生产率的计算与分析

A mathod of controlling the rate of loading and its criterion were also suggested.

还提出了一种控制加荷速率的方法和指标。

Breakeven analysis and power load feature analysis are focused. It elaborates advantages and disadvantages of differential power price influencing power companies from such aspects as sold power quantity 、 market share 、 loading rate.

着重进行了盈亏分析、负荷特性分析，从售电量、市场占有率、负荷率等方面阐述了差别电价对电力公司的利弊。